___________________________________________________________________________________________
Order via E-mail:
E-Mail: info@rhino3d.ch
Tel: +41 (0)2667 40320
Organic Surfacing Tools for Rhino Designers
T-Splines for Rhino
Now Only:
CHF 550.--
The power and ease of subdivision modeling with the precision of NURBS
T-Splines introduces new subdivision surface type workflows into Rhino's precision environment. These workflows, enjoyed for their rapid concept generation by animators, bring the same speed benefit to industrial design. And, for the first time, T-Splines makes them available in a NURBS-compatible, production quality way.
Add detail only where necessary: ...
T-Splines surfaces can contain areas with differing levels of detail..Control points may be added only where needed. A typical T-Splines surface will have up to 50% fewer control points than the identical equivalent set of NURBS.
T-Splines are similar to NURBS, with the difference that you can have partial isoparms.
A main difference between T-Splines and NURBS is T-points. A T-point is a vertex where on one side, there is an isoparm, and on the other side, there isn't. This allows lines of detail to end elegantly. The surface is always smooth (C2) at a T-Point. NURBS don't allow T-Points.
___________________________